i will soon be upgrading,closest dealer is 100+ miles away so cant just pop in and look.
question = are the clutch and brake levers different on the 1100 and will the 696 frame sliders work, i read the comp werks fender eliminator will not fit.
Thats pretty much all i can think of right now?? Anything else you can think of that might be good info ???
Thanks [thumbsup]
Different brake levers and master cylinders for sure. Not sure about the rest. FWIW, the M1100 has the same levers and reservoirs as my S4RS.
good to know just trying to figure out what i will be buying...... again......
I dont see why the CW eliminator wont work.
apparently the special exhuast valve on the 1100 is in the way of the CW tail.
DP sells a fender eliminator kit that works with the 1100 or so I've read
Yes, the 696 frame sliders will fit the 1100 frame since they're the same. I had RhinoMoto barends which accomodated my CRG LS mirrors, however the diameter of the 1100 bars are slightly smaller. I believe amcloud just took off the tube which the expansion bolt presses against and it fit. I haven't gotten around to try it since I'm out of commission due to ACL reconstructive surgery.
I don't believe the levers are the same, but I wasn't planning on changing them so I really don't know. One big diff between the 696 and 1100 is the clutch release. I changed out my 696 to CRG adjustable levers since it was such a far stretch to get into the friction zone. With the 1100, it grabs almost immediately so I didn't feel the need to replace my levers. I ordered termis instead. [thumbsup]
Oh, if you get the full termis, you can use the CW tail. And yes, I ordered the full termis!