Print Page - Mirror set up for clip-ons?

Title: Mirror set up for clip-ons?
Post by: 1313 on June 08, 2009, 04:52:54 PM

I'm getting really close in purchasing a set of Speedymoto clip-ons once I hear back from Desmoworks about the availability.

Right now I have Rhinomoto bar ends with CRG Hindsight LS mirrors. I'm pretty sure the bar ends will not fit the clip-ons. With that said, what is the best and kosher way to secure the CRG mirrors to the new bars? Just clamp them on at the end like the picture below?

(http://www.constructorsrg.com/images/mirrors/image_large_hindsight_ls_d.jpg)

Title: Re: Mirror set up for clip-ons?
Post by: Scoby2duc on June 08, 2009, 05:08:36 PM

my CRGs came with a adapter that worked just fine on mine

Title: Re: Mirror set up for clip-ons?
Post by: herm on June 09, 2009, 04:19:35 AM

the picture posted has the adapter.........and should fit inside the clip ons without issue

Title: Re: Mirror set up for clip-ons?
Post by: 1313 on June 09, 2009, 04:29:26 AM

Thanks. The picture looked like it was just clamped on..

Title: Re: Mirror set up for clip-ons?
Post by: rockaduc on June 09, 2009, 01:59:41 PM

I have the LSL clip ons and I just clamped my CRG LS mirrors to the ends. No probs.

Title: Re: Mirror set up for clip-ons?
Post by: Goduc on June 09, 2009, 02:36:43 PM

I used the CRG mirror with my clip-ons. The original adapter didn't work because the ID (inner diameter) was too small for the adapter to fit. So my fix was to head over to lowes and buy a longer screw that would allow the wedges to separate more.

Ducati Monster Forum

Moto Board => Accessories & Mods => Topic started by: 1313 on June 08, 2009, 04:52:54 PM