I have an '02 M620ie and the neutral light on the gauge cluster just up and quit working. I know that the light is good, as it goes on when the gauges cycle at startup. I expect thast there is a switch somewhere on the bike that has decided to die, and my question is: where would I look for that switch?
Any help would be appreciated.
Jeff
The switch is in the back of the engine in a recess. There is a single wire attached to it. If you ground that wire with the key on the neutral light should illuminate.
Thanks Howie.
I'll check it out tomorrow.
Happy Independence day to you (Assuming you're in the states, of course.).
Jeff
Found it.
Wire pulled off the switch.
Once I knew where to look it was obvious.
Thanks again Howie.
Jeff