Does anyone have a set of Ignition Control Units (Kokusan "boxes") that I could borrow - as I'm having trouble getting my bark to start (engine turns, but no spark - have followed manual and suggestions on Tech forum).
Preferably someone near 75 and Knox - Henderson in Dallas. Thanks!
(https://uploads.tapatalk-cdn.com/20171019/944035655774871e247131c2b70f9e89.jpg)
Quote from: greenohawk69 on October 19, 2017, 03:52:11 PM
Does anyone have a set of Ignition Control Units (Kokusan "boxes") that I could borrow - as I'm having trouble getting my bark to start (engine turns, but no spark - have followed manual and suggestions on Tech forum).
Preferably someone near 75 and Knox - Henderson in Dallas. Thanks!
(https://uploads.tapatalk-cdn.com/20171019/944035655774871e247131c2b70f9e89.jpg)
Found I had the Ignitech control module and am using that. Bike starts and runs.
Advance map for degrees and RPMs is a work-in-progress. Most likely need new jet kit as they're the same as when I bought the bike in '07.
I made a complete wire loom for my Ignitech setup. The one you are using plugs into the old wiring. The difference is noticeable, and it also dumps about 8oz of wires and old connectors.