I need a voltage regulator for my 2007 S4RS. I searched the threads here and there were some ideas but mostly they are 5 years old. Any new sources?
https://ricksmotorsportelectrics.com/Hot-Shot-Ducati-Rectifier-Regulator-10_029H
Check with them by phone before ordering, or just check the length of the leads on the regulator that is on your bike.
What Howie said. ^
Thanks for the quick responses!
That looks like a good choice.
I will order from Rick's.
as a fellow 2007 S4RS owner, could you take a few pictures of the replacement process. I'm thinking i should replace mine before the thing fails when i'm out on highway 94
Sure!
Unfortunately I already replaced it, but I did write a procedure.
1. Remove seat
2. Remove left-hand side cover
3. Unstrap 2 rubber wire ties
4. Unplug both connectors going to the regulator:
3-pin yellow wire coming from stator
4-pin power output
Do this by depressing the tab lock on each connector
5. Unscrew regulator
The right-hand side has a 10-mm nut underneath! Hold this with a wrench and don’t drop the nut
Assembly is the reverse of above
I took a couple of pictures, but I have to admit I do not know how to insert them. If you tell me, I will post them. When I hit "insert image", it inserts [img]
Quote from: vincep99 on July 19, 2019, 12:22:57 PM
Sure!
Unfortunately I already replaced it, but I did write a procedure.
1. Remove seat
2. Remove left-hand side cover
3. Unstrap 2 rubber wire ties
4. Unplug both connectors going to the regulator:
3-pin yellow wire coming from stator
4-pin power output
Do this by depressing the tab lock on each connector
5. Unscrew regulator
The right-hand side has a 10-mm nut underneath! Hold this with a wrench and don’t drop the nut
Assembly is the reverse of above
I took a couple of pictures, but I have to admit I do not know how to insert them. If you tell me, I will post them. When I hit "insert image", it inserts [img]
thanks, were you able to use the same mounting hardware? Was there any change in the physical size of the new VR compared to the old?
I used the same mounting hardware and the new VR was the same size as the old one.