I am in need of a clutch lever. Does anybody have an original laying around?
Actually what I need is the actuator (steel part) that fits into the lever and pushes on the clutch cylinder.
Let me know what you have.
$$ or trade
[wine]
I assume your SS has a Goldline master cyl?
I have original levers for the coffin masters, large pivot, that I'd give away if you or anyone else could use them.
I have the round reservoir also used on older Monster/916/748 etc. Not sure if that is Goldline.
I would like to see if your lever is the same. PM sent.
QuoteI have the round reservoir also used on older Monster/916/748 etc. Not sure if that is Goldline
I'm pretty sure these levers won't work then. There are quite a few levers on e-bay OEM and aftermarket.
Quote from: uefb on August 26, 2008, 06:45:27 AM
I have the round reservoir also used on older Monster/916/748 etc. Not sure if that is Goldline.
I would like to see if your lever is the same. PM sent.
some goldline masters use the larger hollow pivot some have a smaller pivot and it's obvous which one is which (as one is not hollow) I just put goldlines from a 916 on my 620 to replace the coffins and the levers are the same as I crossed over my crg's. One of the best mods I've done yet. I don't know when they switched but by looking at a photo you should be able to tell what will work and what will not. [bacon]