SR4t "project" - updated 4/2/11

[1KDS]

Looking great   
Is that the Desmoworld headlight or did you fab it up?

[TAftonomos]

Heat formed lexan
Bi-xenon projector housing
stuck inside a stock monster bucket.

[1KDS]

Nice, paint the bars black, get your line and cables and go ride that thing!

[TAftonomos]

Slow progress, but the wheel/rotor/caliper combo is finally working together.

Those are some Ohlins FG forks intended for a 916-996 bike.  The wheel is from a 999, the rotors are WSBK Brembo's with zero offset and some funky bolt holes.  Bolts are Ti, calipers are stock 1098 "monoblocks".

Getting this combo to work together has been a pain in the ass, but it seems like it's finally fitted up/torqued down, and clearances are working.  I don't think I'll ever attempt to frankenstein a front end together....I did it cause I had the parts, and they are unique enough I was having trouble selling them.

Anyway, sneek peek:

[stopintime]

I was going to complement you on a job well done, rave about those wheels and fork lowers,
beg for more photos and wish you a very merry Christmas.....


,but



now I have to report you, sue you and/or shoot you ....
.... your new avatar is just beyond acceptable

[Raux]

+100 

[TAftonomos]

LMAO.

I thought Raux would like the Hoff most of all.  He's nearly a national hero in Deutschland. 

[Raux]

LMAO.

I thought Raux would like the Hoff most of all.  He's nearly a national hero in Deutschland. 

You forget I'm old enough to remember KnightRider.

KIT would not approve of that avatar

[Bill in OKC]

   bravo on the front end

The avatar...  not so much.

[junior varsity]

Front end looks great! I just finished mine as well. A little more straightforward than yours but still quite involved. BST wheel, sbk forks w ohlins guts, Ti bolts and nuts, TPO axle, IMA triples, ISR monoblocks and rotors, MW or Mad-Duc speedo replacement spacer and whatnot. I'll post pictures separately so as not to confuse the thread I figure.

I did all this and now I am left to figure out a gauge setup. Oops. Hopefully you aren't left with any such predicament. Looks like I have an excuse to lower the headlight too.

[TAftonomos]

Brackets done, off to He-Man for some powder coating....



Also got my new rotors finished up, buttons installed.  Ended up changing the front around a bit...didn't like the clearance with those rotors...and they were nearly a pound heavier per side!

[koko64]

Hard to know what to say. Just taking it all in.
What a great job. Guys like you show the way.

[TAftonomos]

Shorter trottle cable, check

Brackets colored up, check.

Waiting on a black clutch line, a rubber mounting piece for the rearsets, and the 2 large bolts for the rearsets.  A minor bit of wiring to get the on/PL/off switch to work (so I can start the bike without having the HID bulb start/stop suddenly), and I'll get to try out all the mods.  Weird...I've been through 12 different bikes in the past 3 years, but never once thought of selling the monster.

After the season is over I plan to attack the instrument cluster, and possible strip it down for a color change/aluminum subframe mod.  Can't see doing anything else after that, but you know how that goes...

[junior varsity]

sweet!

need a pic from a distance though.

[greenmonster]

Cooool, looks great!