Looking good over here this morning...

Same here 

See you at JJ...

Thanks for leading today Gene!  Good lead but too bad about all the traffic we ran into.  Still fun......... 

Lotta fun here too despite the "Sunday Drivers"...and thanks for the compliment!...

I think today was the first time I felt my front was lose (in the air) coming out of a uphill right hander on Tantalus.   

Quote from: sta on May 27, 2013, 01:19:28 AM
I think today was the first time I felt my front was lose (in the air) coming out of a uphill right hander on Tantalus.   

Watch out now.  Big difference between loose and lose.      Or not......... 

Yup, loose. 

No riding for me tmrw, flying to phoenix tonight for a week.  See u guys next week. Have fun!

Quote from: sta on June 01, 2013, 08:21:39 PM
No riding for me tmrw, flying to phoenix tonight for a week.  See u guys next week. Have fun!

I'm out also...

I think I'll go to the shop & do some welding.

It's all rainy on this side of the island anyway today.

Quote from: MacDuck on June 01, 2013, 08:54:22 PM
I think I'll go to the shop & do some welding.

How did the welding go?...btw, you're not fabbing up that stretched swingarm for the 848 that you were talking about are you?...

Quote from: 'fighter pilot on June 02, 2013, 08:54:16 PM
How did the welding go?...btw, you're not fabbing up that stretched swingarm for the 848 that you were talking about are you?...

It went just fine right up until the end. Well, almost the end. I have a small bit to do over.  I forgot that a big vice grip clamped onto the piece could be such a big hit sink when it's being held in a vice.

I'm fabbing a tool to tighten down cylinder head nuts on Ducati's.  You could use it to remove them too but this will work to get the proper down torque. Funny thing is that I don't know if I'll ever use it.  Never say never.  This is oxy/acetelyne welding.  The swing arm takes TIG/MIG welding.  That comes later.   

Weather's supposed to be nice tomorrow...