Is it necessary to bleed the brakes and the cluch fluid when installing these or can you clamp it off at the tube swap reservoirs?

they should be bled

if your good enough to do it without introducing airbubbles then your fine. but if you have to ask....then yes bleed it.

Try it, You will know right away if you need to bleed. Even the smallest air bubble will make the lever feel flat and mushy.

just bleed it... its not THAT much work...

watch out for leakage after install,,, dont overfill

I didn't bleed them last time i installed new ones ,air goes up so

What type of brake fluid do our bikes take???

What do you guys recomend for brake and clutch fluid?

DOT 4

What size resevoir are you using?  I checked out the Rizoma sight but wasn't sure. 

I bought (2) 26 ml bottom outflow and (1) 27mm side outflow for the front brake. You may want to go even smaller on the rear brake because it's alittle tight down there. I haven't put them on yet. If your thinking of getting them go through PJ's Parts. They are very fast.

Quote from: Bbrent on August 08, 2008, 01:24:57 PM
I bought (2) 26 ml bottom outflow and (1) 27mm side outflow for the front brake. You may want to go even smaller on the rear brake because it's alittle tight down there. I haven't put them on yet. If your thinking of getting them go through PJ's Parts. They are very fast.

Thanks for the info, anyone running anything different?

These

What size/volume are those?  to be honest I don't know what the stock volume is.  Look nice!

The mounting bracket that came with the Rizomas are straight. Did you have to ben yours to work?