I took off my stock mirrors on my 2007 S4RS and went with the CRG bar end mirrors. The question is, what do i use to fill in the ugly holes where the stock mirrors were? One time i saw a nice decorative billet screw in plug made for that purpose, but i forget which site i saw them on and now i cant find them again!!! Anyone know of a place to get something to put there?

Thanks!

I just flipped that side of the clamp so that the hole faces down. 

Quote from: Takster on July 15, 2009, 07:05:57 AM
I just flipped that side of the clamp so that the hole faces down. 

+1

flipping only works for the coffins... the goldlines clamp from the top.

you can look for the clampy bits from brembo to replace the ones that are threaded for mirror mount

5/16" plastic plug from Lowes

i say screw the holes and just ride it mirrorless.  thats how i roll.

^^same here.

Quote from: teddy037.2 on July 15, 2009, 08:44:52 AM

you can look for the clampy bits from brembo to replace the ones that are threaded for mirror mount

and if you look at yoyodyne, you'll find them...

Quote from: Takster on July 15, 2009, 07:05:57 AM
I just flipped that side of the clamp so that the hole faces down. 

Brilliant!!!
Just swapped stock for CRG, got the plastic thingy's from Lowe's and still didn't like the look. Saw your post and walked out to the garage and flipped 'em.

I can't believe I didn't think of that!!!

Thanks Takster!!!

A couple of stainless or black allen head screws(6mm-1/4 inch  diameter) with some plastic or rubber hose (6mm-1/4 inch internal diameter) over the thread to bring them up to the diameter of the holes, screw them in, away you go should cost you about $2-00

great idea DC