Quote from: Xerxes1769 on December 22, 2009, 07:35:06 AM
Will,

Would either of these pumps work on my monster?

http://cgi.ebay.com/ebaymotors/DUCATI-08-MONSTER-S2R-1000-OEM-GAS-FUEL-PUMP-PUMPS_W0QQitemZ190357647144QQcmdZViewItemQQptZMotorcycles_Parts_Accessories?hash=item2c52332f28

or

http://cgi.ebay.com/ebaymotors/05-06-Ducati-Multistrada-1000-DS-S-Fuel-Pump-MINT_W0QQitemZ250509851441QQcmdZViewItemQQptZMotorcycles_Parts_Accessories?hash=item3a538cfb31

or

http://cgi.ebay.com/ebaymotors/Ducati-Multistrada-620-fuel-pump-gas-pump-2006_W0QQitemZ260527020396QQcmdZViewItemQQptZMotorcycles_Parts_Accessories?hash=item3ca89ed96c

I figure this might be faster than waiting until you guys hear from Ducati.

Let me know.

Thanks!

s2r assemblies and 620' s will work, hope you get a good one.
let us know
happy holidays
-will

Will,

I ended up buying the S2R1000 fuel pump...(since it was the newest and less mileage one)

http://cgi.ebay.com/ebaymotors/DUCATI-08-MONSTER-S2R-1000-OEM-GAS-FUEL-PUMP-PUMPS_W0QQitemZ190357647144QQcmdZViewItemQQptZMotorcycles_Parts_Accessories?hash=item2c52332f28

should be here hopefully by the end of this week, I put the fuel pump/flange I had ordered from you guys on hold just in case this pump doesn't work.  As it turns out the Ducati factory is on a month long vacation and my pump was going to take a lot longer than I was previously told.  So hopefully this will work and I can get the bike out sometime soon.  

Also bought some new brake/clutch reservoirs and was hoping you guys could install them...they should be here end of this week...

for clutch and brake


and for rear brake

Your bike has the coffin masters right?

Yes Sir!  Coffin style and fugly as all hell!  Don't tell me they will not fit!?!

Well, those are a one piece design.  The reservoir is permanently attached to the master cylinder if I am not mistaken...

Dang!  Now to see if I can switch the three reservoirs for something else...

yes, the pump...good
the brake and clutch stuff, nope, no worky,

let us know when you get the pump

Will,

Dropped off the pump and got a look at the bike...the clip-ons look fantastic!  Hopefully pump will fit and work and I can get the bike back soon.

Will,

Bike's running great so thanks!

no, no need to thank, thank you

yes, yes need to thank.  you thanked.

har har

 

Aloha Will,

Bringing the S4RS in for safety check Friday and change the front rotors/pads to stop the jurging.  Dropped off new BrakeTech rotors with Shawn when I made the appointment.  The rub is there's a little caution note on the installation sheet that says the stock bolt shoulders may not fit the rotor hubs.  I want to go new bolts anyhoo so I'm hoping you could maybe check the fit before Friday so if there's a problem maybe it can be addressed before the appointment.

Mark

ok, i'll take a look tomorrow

see ya on fri