Pretty sure the M1000Sie's had goldline masters...

Quote from: DRKWNG on October 20, 2011, 05:20:27 PM
Pretty sure the M1000Sie's had goldline masters...

Yes I got the masters and the calipers off the same bike ... with lines ... the only black caliper now is the rear one ... but, I only use it on traffic lights and very very emergency braking situations

Quote from: Moto Mecanica PTY on October 20, 2011, 04:49:24 PM
Is it a good offer, good enough to leave Paradise?

it wasn't anything official, and if it were to even happen, I'd be taking a pay cut.

then add the headaches of dealing with this place, finding a new place, the cost of moving, etc. 

but the pros would be the intangibles of the work environment, the ability to road-trip, etc.

Quote from: teddy037.3 on October 20, 2011, 04:55:15 PM
also getting pretty tired of the 4k surge... I might need to start saving my pennies for a 14T and DP ECU

Do your research before you pop for the DP ECU as the newer ones run closed loop below 5k rpms and will not cure any fueling issues below that point...you'll more than likely need an ECU reflash ($250-$300) unless you want to go with something tuneable like the Bazzaz...FatDucs are a less expensive option if available for your bike,  but won't do the job as well as a reflash...good luck!

if the race kit eliminates the cat and O2 sensors, wouldn't that cease to be closed loop? i'd imagine the DP ECU that comes with that would be ok

Quote from: teddy037.3 on October 20, 2011, 07:36:13 PM
if the race kit eliminates the cat and O2 sensors, wouldn't that cease to be closed loop? i'd imagine the DP ECU that comes with that would be ok

The race kit ECU runs in closed loop mode on newer Ducatis, from 2009 and onward I believe...see below response from DNA in reference to a letter regarding this subject from a fellow F1098 owner...

Dear Mr. Kloss,

Thank you for contacting Ducati North America.

We are happy to hear that you are pleased with the performance of your new Ducati Streetfighter. In regards to your question about the Full Racing Exhaust Kit, this is a closed loop system. We hope that you continue to enjoy this wonderful machine.

If you have any further questions, please feel free to contact us or an Authorized Ducati Dealership. To find an Authorized Ducati Dealership, please visit www.ducatiusa.com and click on "Dealer Locator" or utilize our dealer locator by phoning 1-800-231-6696.

Best regards,

Customer Service
DUCATI North America
10443 Bandley Drive
Cupertino, CA 95014

Quote from: DRKWNG on October 20, 2011, 01:53:55 PM
Did somebody say "GET OFF MY LAWN"?  

Funny you should say that. I was thinking "Walt" when I was posting the reply.  

Quote from: 'fighter pilot on October 20, 2011, 06:19:35 PM
Do your research before you pop for the DP ECU as the newer ones run closed loop below 5k rpms and will not cure any fueling issues below that point...you'll more than likely need an ECU reflash ($250-$300) unless you want to go with something tuneable like the Bazzaz...FatDucs are a less expensive option if available for your bike,  but won't do the job as well as a reflash...good luck!

All of that is true for the most part. My '09 runs an open loop but it must have been some of the early mods. Will was amazed that Majdi's ECU & cans were set up for open loop. They should have been the closed loop below 5K but for some reason they weren't. Anyhow the throttles and mixtures have to be spot on. On a related note nothing you're running can be as bad as DRKWNG's SD in it's early days. You have no idea how wild surging and backfire can get. At that time the only way around it was to just idle along or ride it harder & harder whilst holding part throttle open as you braked.      

well, then I'm lost...

the dp ecu for the hym796 will retain closed loop, but it will run better.
a remapped/reflashed ecu can be made to be open with that ecu.

kevin, another hym 796 owner got the full system and was happy with the results, he installed it himself being that there is not too much actual adjusting that would be done at the shop

shiny, thanks for the info will 

too bad I don't have any kids to sell for that 2-1...

Didn't mean to cause any confusion, just didn't want to see you spend gobs of $$$ and not get what you were wishing for...

Quote from: MacDuck on October 21, 2011, 12:14:46 AM
Funny you should say that. I was thinking "Walt" when I was posting the reply.  

Quote from: 'fighter pilot on October 21, 2011, 02:49:54 PM
Didn't mean to cause any confusion, just didn't want to see you spend gobs of $$$ and not get what you were wishing for...

np

With a little help from my son and his wife, became a grandfather again today...7 lb 6 oz healthy baby boy...