696 frame slider torque spec

[MadDaddy]

I just purchased a set of Motovation frame sliders for my 696. The install instructions say to torque to owners manual specs for the original motor mount. Well, as you know there are no torque specs in the owners manual. Does anyone know the torque spec for the motor mount that the frame sliders would replace?

[♣ McKraut ♣]

i just consulted the torque specs for the 2007 S4Rs that someone posted on here, and the value for the "Nut for engine-frame bolt" it lists it as being 60ft/lbs.  don't quote me on that, though.

[MadDaddy]

Is that 60 ft/lbs or 60 Nm? I found it some where else listed as 60 Nm. Thanks though!

[causeofkaos]

NM not ft/lbs
"Nut securing subframe/frame to engine M12x1.25 = 60 * GREASE B (on thread and underside of nut) "
"Screw securing subframe to frame M12x1.25 = 60 * GREASE B "
Notice the * nexy to the 60
" * dynamic safety-critical point; tightening torque must be within Nm ±5%. "
Finally i could help someone with data from this manual cd WOO HOO!!!

[MadDaddy]

Thanks Kaos!

[♣ McKraut ♣]

yes, 60 Nm sorry...didn't double-check the column header