Danmoto exhaust

[jc.cyberdemon]

dont really like the look of the strap/hanger thingy but im not really that picky.

[Monster Dave]

I still think that the CF looks cheaply done. The round bolts that hold the CF sleeve on the can itself look awful and give them an unfinished look. However, that being said these may be the best bang for your buck. I will admit that from this video, they don't sound too bad though.

ducati monster 796 escape danmoto

[jc.cyberdemon]

it would be nice to buy the best set i could find but my budget is low and i need new cans because the person before
me chopped them down and did a terrible job. They look like shit and they leak all over and in my opinion are too loud,
so im going to replace them with something i can afford. here is a pic of my current cans....

[junior varsity]

there's a set of NCR/Sil Moto Titanium low mounts on ebay for like 375...

[jc.cyberdemon]

ordered a set of them today so when they come in ill give you an honest opinion of how they work out.

[Triple J]

I still think that the CF looks cheaply done. The round bolts that hold the CF sleeve on the can itself look awful and give them an unfinished look.

Those are standard pop rivets. Many other manufacturers (Remus and Leo Vince for sure) use them as well...Termi might even for their older models.

[junior varsity]

pop rivets is also how you affix some of the "female" brackets for dzus fasteners in bodywork. even fancy carbon bodywork.

[Punx Clever]

I still think that the CF looks cheaply done. The round bolts that hold the CF sleeve on the can itself look awful and give them an unfinished look. However, that being said these may be the best bang for your buck. I will admit that from this video, they don't sound too bad though.

Bah, the only thing missing from the carbon fiber on those cans is a bit of trim along the edges.  A little sheet metal work and a couple of Termi stickers and everyone would be asking where they could get the new slim termi's from!

I never did think an exhaust was worth $1300... and with it sounding like that, I think I was right.  Comparison on cost... custom made 2" stainless x-pipe with 3 chamber flowmasters on a 71 chevelle cost me right at $500.

[jc.cyberdemon]

got em in today! actually came quicker than the stuff i ordered from motorcycle superstore and kneedragers. i ordered them on friday and they showed up today. so far they look great and are really light havent put em on yet so dont know about fitment or sound but will post some pics in a bit! 

[ducpainter]

got em in today! actually came quicker than the stuff i ordered from motorcycle superstore and kneedragers. i ordered them on friday and they showed up today. so far they look great and are really light havent put em on yet so dont know about fitment or sound but will post some pics in a bit! 

Want some 'Toomuchmoney' stickers for them?

[jc.cyberdemon]

sure

[jc.cyberdemon]

if i end up making it out tomorrow i will bring them so you can also inspect and tell me what you think

[ducpainter]

sure

if i end up making it out tomorrow i will bring them so you can also inspect and tell me what you think

Sounds good.

Don't listen to Dave...

opinions are like assholes...everyone has one and they all stink.

[Raux]

Those are standard pop rivets. Many other manufacturers (Remus and Leo Vince for sure) use them as well...Termi might even for their older models.

i have found special rivets that are made for exhausts that seal

[Mojo S2R]

i have found special rivets that are made for exhausts that seal

Where?  Got a link?  I plan on chopping my cans.  Those may come in handy.